This next photo shows the interior mounting bracket ready to install along with the lock and unlock lever
So now the idea is the lever has to go into the little slot on the front of the interior mounting bracket and connect to the rod that locks and unlocks the motor tilt. So you slide the lever into place and it hits the various pieces on the bracket. And guess what it does not work. So I fiddled around with it and finally figured out that the lever does not go in straight, it goes back into one of the pockets. The picture shows how the lever fits back in there and hooks up to everything.
You will also notice in the picture that one of the side brackets is already installed. This just makes it easier at this point. Next slide the lock bracket into place and slide on the other bracket. Then put the retaining nut in place. The end result from the backside should look something like this. You can also see the spring that keeps the tilt pin lock in its proper place.
So here it is all back together and ready for the next step of assembly.
No comments:
Post a Comment